You may have problems that can be fixed with a few minor adjustments.
Look for the type of problem you are having below and then try the
suggestions to get your TV going again. For warranty information see page 23.
19
Reference
Trouble Checks
Checks and Adjustments
Remove batteries and hold down one or more buttons for several seconds
to drain the microprocessor inside the remote and reset it. Re-install the
batteries and try remote again.
Clear the path between the remote and TV of any objects.
Aim the remote at the component you are trying to control.
Make sure batteries in the remote are not dead.
See if batteries are placed in remote correctly. See batteries, page 3.
Press number buttons. Channel may not be in memory. See Autoprogram
on page 11.
Make sure TV/VCR switch on VCR is in the TV position.
For numbers over 100, press and hold 1 until 1-- appears, then press the
other two numbers.
Set Cable/Air feature to Cable for channels higher than 69. See page 16.
Turn Stereo off. The stereo broadcast may not be clear. See page 10.
Press
VOLUME
+
or
MUTE
to restore sound.
Try another channel. Try adjusting the Tone. See page 10.
Change Stereo to off. The stereo broadcast may not be clear. See page 10.
Make sure Stereo is turned on. See page 10.
Trouble
Remote
Remote lockup
Works part or none of the
time
Can’t select certain channel
Sound
Noisy stereo reception
Picture okay, no sound
Picture okay, sound poor
No stereo on stereo station