Chapter 2
23
Using the Remote Control
Tip
To turn off all the
RCA, GE, and
PROSCAN
components that are
connected to the TV,
press ON•OFF twice
within two seconds.
This feature only
works with most RCA,
GE and PROSCAN
products.
ON•OFF
Turns the TV on and off. When the remote is in another mode (VCR, DVD, Satellite, etc.)
and the remote is programmed to operate that component, you can press ON•OFF to turn the
component on and off.
PAUSE
If you’re operating a VCR or DVD Player with the remote control, press PAUSE when the disc
or videotape is playing to pause playback.
PIP (Picture-In-Picture)
Brings up the small Picture-In-Picture window. Press again to remove the
PIP window.
PLAY
If you’re operating a VCR or DVD Player, plays the disc or videotape.
REC•VCR+
When the GUIDE Plus+ program guide is on the screen, press REC•VCR+ to program
your VCR to record a program. If the remote is in VCR mode, press REC•VCR+ to start recording.
RESET
Resets original settings in several control panels.
REVERSE
If you’re operating a VCR or DVD Player with the remote control, press REVERSE to go
backwards on a disc or videotape.
SAT•CABLE
Puts the remote in SAT•CABLE mode. If you set up the Auto Tuning feature (Chapter
3), pressing the SAT•CABLE button automatically tunes the TV to the correct channel.
SKIP
If you press this button before you change the channel, the TV waits 30 seconds and
automatically goes back to the original channel. Each time you press SKIP, you add 30 seconds (i.e, if
you press SKIP two times before you change the channel, the TV waits 60 seconds and automatically
turns back to the original channel).
SOUND
Displays the
AUDIO PROCESSOR
menu.
STOP
If you’re operating a VCR or DVD Player, stops playing the disc or videotape.
SWAP
Switches the main picture with the PIP window.
TV
Turns on the TV and puts the remote in TV mode. Also displays channel information.
VCR1
Puts the remote in VCR mode. If you set up the Auto Tuning feature (Chapter 3), pressing the
VCR1 button automatically tunes the TV to the correct channel.
VCR2
Puts the remote in VCR mode. If you set up the Auto Tuning feature (Chapter 3), pressing the
VCR2 button automatically tunes the TV to the correct channel.
VOL (up and down) buttons
Decrease or increase the TV’s volume.
WHO•INPUT
In TV mode, press WHO•INPUT to toggle through the available Video Input channels
(VID/SVID and the current channel). In SAT mode, press to select available channel lists.
Using the WHO•INPUT Button
Use the WHO•INPUT button to toggle through the available input sources (VID and the current
channel) and view the content from the component you have connected to the TV.
1.
Press TV to place the remote in TV mode. Make sure that the content from the component is
turned ON.
2.
Press WHO•INPUT to tune to the available input source and view the component.
3.
Press WHO•INPUT again to tune back to the channel you were previously watching.
