8
Selecting Tuner
1. Press
SOURCE
to select
TUNER
.
2. Press
BAND
to select between FM/AMradio band.
Tip: Your audio system has 32 preset stations.
Tuning to a Station
Press
SKIP FORWARD
/ SKIP BACK-
WARD
to select frequencies.
Using Presets
The tuner can be either TUNE or PRESET mode.
When in PRESET mode, the PROG light is on.
• Press
TUNE/PRESET
to toggle between Preset
and Tune mode.
• Press
SKIP FORWARD
/ SKIP BACK-
WARD
on the
main unit or
PRESET UP /
DOWN
on the remote
control to access the previous or next preset station.
The display first shows the preset program number
and after a few seconds, the frequency will be dis-
played. (FMPR:01 is FM preset 1)
Auto Preset Programming (for FM only)
Press and hold
BAND/DECK1/2/AUTO PROG.
button
for 2 second to scan stations in the selected band. The
stations will then be stored as preset channels. A
maximum of 32 stations can be stored. Beware of
your preset channels being erased accidentally
because the scanning and storing process is automatic
upon pressing the button.
You can stop the automatic scan by pressing any but-
ton, but the erased stations cannot be recovered.
Manually Setting Presets
1. Press
TUNE/PRESET
to enter TUNE mode.
2. Press
SKIP FORWARD / SKIP BACK-
WARD
to access the desired frequency.
3. Press the
PROG. SET
button once.
4. The most recently accessed program location will
be displayed.
5. If a different program location is preferred, press
SKIP FORWARD / SKIP BACKWARD
to move to the desired preset number
(1-32).
6. Press
PROG. SET
to store the selected frequency at
that preset.
Suppressing Stereo Signal
Press
FM ST
to toggle between FM mono and stereo
for stereo FM stations. (Remote Only)
EN
Tuner
87.50 MH
z
PR:01
RS2610-EN 6/14/02 9:32 AM Page 12
