Graphics contained within this publication are for representation only.
Chapter 1
7
Chapter 1: Connections and Setup
Things to Consider Before You Connect
• Connect all devices before you plug any of their power cords into the wall outlet or power strip. Never
plug your TV into an outlet that is controlled by a wall switch.
• Turn off the TV and/or device(s) before you connect or disconnect any cables.
• Make sure all antennas and cables are properly grounded. Refer to the Important Safety Instructions at
the beginning of the User's Guide.
Protect Against Power Surges
• Don’t block ventilation holes on any of the devices. Arrange the devices so that air can circulate freely.
• Don’t stack devices.
• If you place devices in a stand, make sure you allow adequate ventilation.
• If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from it won’t flow
around other devices.
Protect Devices from Overheating
• Insert each cable firmly into the designated jack.
• If you place devices above the TV, route all cables down the side of the back of the TV instead of straight
down the middle.
• If your antenna uses 300-ohm twin lead cables, do not coil the cables. Also, keep the twin lead cables
away from audio/video cables.
• Use shielded interface cables with ferrite cores to maintain compliance for this product.
Position Cables Properly to Avoid Audio Interference
Don’t place the TV where sunlight or room lighting will be directed toward the screen. Use soft or indirect
lighting.
Use Indirect Light
You will need a master remote or USB Cloner to set up the TV. Contact your RCA Commercial Distributor to
purchase these.
Remote Control
Check that the following parts were packed with your product.
Check Supplied Parts
Power Cord
Owner’s Manual
Note
- If you need to replace your remote, call 1-800-RCA-2161. A shipping and handling fee, and the appropri-
ate sales tax, will be charged upon ordering.
- Stand Base, Stand Body images shown may differ from your TV.
Stand Base
Stand Body
1
2
3
4
5
6
7
8
9
0
SYSTEM
GUIDE
SLEEP
SKIP
CC
GO BACK
ANTENNA
INPUT
SOUND
MENU
OK
INFO
CLEAR
MUTE
CH
VOL
VOL
CH
ON-OFF
C O M M E R C I A L
R130K1
Remote
(Optional)
