Other Information
26
Chapter 4
Mounting Your TV to the Wall
Caution:
The wall mount must bear a minimum of fi ve times
the TV’s net weight without causing damage.
Your TV comes with a wall mount plate that attaches to the back of
your TV and allows you to mount the TV to the wall. You need to
purchase a VESA compatible wall mount to mount your TV to a wall.
Purchase a VESA wall mount that has mounting measurements of
200mm horizontally and 100mm vertically for model L26W11; and one
that has mounting measurements of 400mm horizontally and 200mm
vertically for model L32W11.
To attach the plate:
1. If your TV is attached to the base, you need to remove it fi rst in
order to attach the plate.
A. Place the TV facedown on a surface that is soft, yet strong
enough to hold the TV.
B. Remove the two jack panel covers by pushing up on the tabs
and pulling the covers out carefully.
C. Use a screwdriver to remove the screws from the four holes on
each side of the TV’s base as the arrows indicate on the base.
2. Make sure all devices are already connected, then put the covers
back into place over the jack panels.
3. Locate the wall mount plate.
4. Hold the plate so the printing is upright and facing you.
Determine the holes to use for your model as indicated on the
graphic to the left. The holes for your model are in the same
location on each corner of the plate. Attach the plate to the back
of the TV with four of the eight screws used to attach the base.
5. Follow the directions included with the wall mount to mount the
TV to the wall.
Attach plate using these holes.
Attach plate using these holes.
Remove the two jack covers to remove the
base.
Remove the screws from the four holes on
each side of the TV’s base.
L26W11
L32W11
1652880A.indb 26
1652880A.indb 26
8/22/05 4:16:01 PM
8/22/05 4:16:01 PM
