SYMPTOMS
POSSIBLE CAUSE
REMEDY
Door will not operate
Main power not turned on
Turn on
Door is obstructed
Remove obstruction
Fuse blown
Replace fuse
Door will not operate
Door reversing sensitivity not
Re-adjust reversing sensitivity
adjusted properly
(Ref installation instruction step 7)
Door moves downwards
Door reversing sensitivity not
Re-adjust reversing sensitivity
and reverses itself upwards
adjusted properly
(Ref installation instruction step 7)
Door operates from drive
Indicator on transmitter
Battery flat of battery leads broken
unit but not from hand transmitter
not lighting
Transmitter has not been learnt
Refer to installation
instructions - step 8
Drive unit aerial wire not extended
Extend aerial wire
Battery flat
Replace battery
Door does not close fully
Limit micro switch
Re-adjust limit switch
incorrectly adjusted
(refer to intallation
instructions step 6)
Door does not open fully
Limit micro switch
Re-adjust limit switch
incorrectly adjusted
(refer to intallation
instructions step 6)
lights not functioning
Bulb blown
Replace bulb
Bulb keeps blowing
Incorrect bulb
Replace with 24V 5 Watts
Festoon bulb
FAULTS AND REMEDIES
Specifications
INPUT VOLTAGE:
110/220V AC 50Hz
Single Phase.
Current Required
1 Amp
TRANSFORMER SPEC:
Primary Voltage
110/220 VAC
Secondary Voltage
24V AC/100VA
MOTOR SPEC:
Motor type
Permanent Magnet DC Motor
Torque
150kg cm at 4 Amps
OPENER LIFTING CAPACITY:
30kg
CONTROL BOARD SPEC:
Relay Contact Rating
12 Amp/30V DC
Relay Coil Voltage
24V DC
Control Board Voltage
24V DC/5V DC
Light Globe Voltage
24V DC 5 Watts
Receiver Specification
Receiver Type
FSK AM
RF Frequency
433.92 MHz
Code Storage Capacity
6 different codes
Control Distance
>50m
TRANSMITTER SPEC:
Carrier Frequency
433.92 MHz
Current Consumption
50mA (approx.)
Battery Voltage
12 Volts
Coding Format
Rolling Code (7.38 x 1019 Code Combinations)
