7
PREPARATION
You must connect a TV to the system in order to use the system’s
DVD player. You can also connect other audio and audio/visual
components to the system.
PLACEMENT
• Do note expose the unit to dripping or splashing.
• Do not use the unit in places which are extremely hot, cold,
dusty, or humid.
• Place the unit on a flat and even surface.
• Do not restrict the air flow of the unit by placing it in an area
with poor air flow, by covering it with a cloth, or by placing it on
carpeting.
SAFETY
• When connecting or disconnecting the AC cord, grip the plug,
not the cord itself. Pulling the cord may damage it and create a
hazard.
• When you are not going to use the unit for a long period of time,
disconnect the AC power cord.
CONDENSATION
When left in a warm or damp room, water droplets or condensation
may form inside the unit. When there is condensation inside the
unit, the unit may not function normally. Let the unit stand for a few
hours before turning the power on, or gradually heat the room up
and dry the unit before use.
Warnings:
• Should any trouble occur, disconnect the AC power cord and
refer servicing to a qualified technician.
• Do not place anything directly on the top of the unit. Damage to
the unit can result. This product contains a low power laser
device.
Note: The system comes with one set of audio/video cables. Your
local RadioShack store sells a wide variety of audio/video cables if
you need additional cables to connect more components.
INSTALLING BATTERIES IN THE REMOTE
CONTROL
Your remote control requires two AA batteries (not supplied) for
power.
1. Press in on the tab on the
battery compartment cover,
and lift to remove it.
2. Place the batteries in the
compartment as indicated by
the polarity symbols
(+ and –) marked inside.
3. Replace the cover.
When the remote control stops
operating properly, replace the
batteries.
Notes:
• Do not burn or bury batteries.
• Dispose of old batteries promptly and properly.
• Use only fresh batteries of the required size and recommended
type.
• Do not mix old and new batteries, different types of batteries
(standard, alkaline, or rechargeable), or rechargeable batteries of
different capacities.
• If you do not plan to use the remote for a month or longer,
remove the batteries. Batteries can leak chemicals that can
damage electronic parts.
