EN-2
CAUtIon: to ReDUCe tHe RISK of eLeCtRIC
SHoCK, Do not ReMoVe CoVeR (oR BACK).
n o U S e R S e R V I C e A B L e P A R t S I n S I D e .
RefeR SeRVICInG to QUALIfIeD SeRVICe
PeRSonneL.
WARnInG:
TO PREVENT FIRE OR ELECTRICAL
SHOCK HAZARD, DO NOT EXPOSE THIS PRODUCT
TO RAIN OR MOISTURE.
CAUtIon
: DANGER OF EXPLOSION IF BATTERY IS
INCORRECTLY REPLACED. REPLACE ONLY WITH
THE SAME OR EQUIVALENT TYPE.
WARnInG:
T H E A C A D A P T E R I S U S E D A S
DISCONNECT DEVICE AND IT SHOULD REMAIN
READILY OPERABLE DURING INTENDED USE. IN
ORDER TO DISCONNECT THE MAINS PLUG FROM
MAINS COMPLETELY, THE AC ADAPTER SHOULD
BE DISCONNECTED FROM THE MAINS SOCKET
OUTLET COMPLETELY.
Caution: This product utilizes a laser. Use of
controls or adjustments or performance of
procedures other than those specified may result
in hazardous radiation exposure. Do not open
covers and do not repair yourself. Refer servicing
to qualified personnel.
CLASS 1 LASER PRODUCT
This product contains a low
power laser device.
fCC information
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the
equipment and receiver.
– Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
– Consult the dealer or an experienced radio/
TV technician for help.
WARnInG:
Changes or modifications to this
unit not expressly approved by the party
responsible for compliance could void the
user's authority to operate the equipment.
CAn ICeS-3(B)/nMB-3(B)
This product complies with DHHS Rules 21 CFR
Subchapter J. Applicable at the date of manu-
facture.
Useful advice
• Do not use your system immediately after
transporting it from a cold place to a warm
place, as condensation may cause the
system to malfunction. If moisture forms
inside this system, it may not operate
properly. To correct the problem, turn off
the power and wait about 30 minutes for
moisture to evaporate.
• Never leave the tray open as dust could
cover the laser lens and/or the tray could
be bumped into accidentally.
• Do not place the system near wet areas
such as bathrooms and pool side. Avoid
storing the system at humid places or near
abnormally heated areas.
• Power is continuously supplied to the
system. To disconnect power completely,
unplug the AC adapter from the power
outlet.
• Ensure minimum distance around the
apparatus for sufficient ventilation. The
ventilation should not be impeded by
covering the ventilation openings with
items, such as newspaper, etc.
• No naked flame source, such as lighted
candles, should be placed on the apparatus.
technical information
Power Supply: DC IN 12V
SAFETY PRECAUTIONS
