5. Starting with the number 1 key,
press and release each number key
on the keypad in the following
order (1-9, then 0). The number
that causes the illuminated
ON•OFF
key to blink is the first
number of the code. As you find
each number of the code, refer to
the code boxes below and write
them down for future reference.
Note:
All TV codes begin with the
number 1; all VCR codes begin
with the number 2; all DVDs, the
number 3; and all satellite
receivers and cable boxes, the
number 5.
6. Repeat step 5 until you have
retrieved all four numbers in
the code.
7. After the fourth number is
retrieved, the illuminated
ON•OFF
key blinks briefly, then turns off.
8. To exit the Code Retrieval Mode,
press and release the
GO BACK
key at any time.
9. If you press an invalid key during
the Code Retrieval process, the
remote will not respond. If you do
not press a valid Code Retrieval
key (
TV
,
VCR•DVD
,
SAT•CBL
,
INFO
,
GO BACK
), Code Retrieval
times out after 15 seconds. The
illuminated
ON•OFF
key blinks
four times, and then turns off.
12
Because this remote controls more than one component, you
must first “tell” the remote which component you wish to
operate. That means, if you wish to operate your TV, you
must first press the
TV
key to put the remote in the TV Mode.
The remote stays in the chosen component mode (such as TV
Mode) until you change it. If your remote is in TV Mode, you
must change the mode in order to operate your DVD or VCR,
satellite receiver or cable box. For example, if you are in VCR
Mode, and you wish to turn off your TV, you must press the
TV
key first before pressing the
ON•OFF
key.
Using the Remote to
Control Your Components
GO BACK
TV CODE
1
SAT
·
CBL CODE
5
ON•OFF
ON•OFF
(BLINK)
VCR
·
DVD CODE
Code Retrieval (continued)
RCR311S_NA_IB_REVB_K4.qxd 7/27/04 11:41 AM Page 12
