16
Examples
To set up Smart Source to use volume commands to control your
TV:
Press
TV
PROG
VOL+
To automatically select your cable box whenever you wish to
change channels:
Press
CBL
PROG
CH+
The COMMAND light flashes three times and the remote
responds:
“Smart Source On.”
To turn Smart Source on and off:
Press the following button sequence:
TV
PROG
7
PROG
. The
remote responds:
“Smart Source Off.”
Learning buttons from other remotes
The RCA Voice Control Remote can learn functions from other
remotes, either to add to an existing programmed device or to
“build” an entire set of codes for a device from scratch.
Note:
Before you begin the learning process make sure that the
batteries in the “teacher” remote are new.
To learn a new button to the RCA remote:
1.
Position the RCA Voice Control Remote and your “teacher”
remote as shown here.
1–4”
2.
Press the device button (
TV
,
SAT•CBL•DTC
,
DVR•AUX1
,
VCR•AUX2
,
AUDIO
,
DVD
) where you want to put the
learned codes. The device button can have a device already
programmed, or it can be unprogrammed.
3.
Press
PROG
, then
3
, then
PROG
. If sound is turned on, the
remote will prompt you through the process.
Note:
You can learn a sequence of buttons through the HELP
system by pressing
HELP
2
.
4.
Press the button on the RCA Voice Control Remote you want to
use for the learned function.
Note:
Not all buttons can be taught new functions. You
cannot learn onto the following buttons:
TV
,
VCR•AUX2
,
DVD
,
SAT•CBL•DTC
,
AUDIO
,
DVR•AUX1
,
PROG
,
TRAIN
,
SOUND
,
LISTEN
,
LIGHT
or
HELP
.
The RCA remote’s COMMAND light illuminates. If sound is on,
the RCA remote responds:
“Press the button on the remote
you are learning from.”
5.
Press the button on the teacher remote that you want to
transfer to the RCA Voice Control Remote. Hold the button
on the teacher (source) remote until the RCA Voice Control
Remote makes another sound.
NOTE:
Proper positioning of both remotes is very important to get a
good transfer of information between the two remotes.
If you hear
“Good”
, then the button was captured successfully.
If you hear a
“braap”
sound, the RCA Voice Control Remote did not
learn this button. Try adjusting the range or position and try again.
