7
Program for Satellite or Cable Box—
Direct Entry Method
DBS•
CABLE
1. Manually turn on the satellite
receiver or cable box.
2. Locate the enclosed Satellite or Cable
Box Code List. Find your brand in the
Satellite Codes or Cable Box Codes
section, respectively.
Note:
If your brand isn’t listed,
use one of the Code Search methods
to program this remote control
(See Code Search on page 8).
3. Press and hold the
CODE SEARCH
key until the indicator light illuminates.
Then release the
CODE SEARCH
key.
4. Press and release the
DBS•CABLE
key. The indicator light blinks and
then remains lit.
5. Use the number keys on the remote to
enter the first code listed for your brand.
After you enter a valid three-digit
code, the indicator light turns off.
Note:
If you enter an invalid code, the
LED will flash rapidly for 2 seconds.
Start over at step 3.
6. Aim the remote at your satellite
receiver or cable box and press
the
ON•OFF
key. If your Satellite
receiver or cable box turns off, you
have found the correct code.
7. Enter the code in the box provided
on this page for future reference.
8. If your satellite receiver or cable box
doesn’t turn off, repeat steps 3-6 above,
entering the next code for your brand.
If none of the codes work or your
brand is not listed, use one of the
Code Search methods to program
this remote (See Code Search on page 8).
For a description of each key on the
remote control, refer to the Key
Descriptions section page 3-4.
In order for the 3 component universal remote to control
your satellite or cable box, you must program it with the code
that matches your component. The
DBS•CABLE
key can be
programmed to operate either a satellite receiver or a cable
box. These instructions explain the preferred method of
programming the remote—the Direct Entry method.
DBS (SATELLITE)
OR
CABLE BOX CODE
ON•OFF
(BLINK)
(OFF)
1
2
3
4
5
6
7
8
9
0
CODE
SEARCH
INDICATOR
LIGHT
RCU310_US_IB_REVB 4/10/03 16:43 Page 7
