Congratulations on your purchase of the six-component universal remote by RCA. This universal remote
controls up to six electronic components and makes juggling remote controls a thing of the
past. You can program this RCA universal remote to operate most models of most brands of infrared,
remote-controlled components manufactured after 1990. (See enclosed Code List for a complete list
of brands.) The six-component universal remote is easy to use, easy to program and gives you control at
the touch of your fingertips.
Note:
The six-component universal remote is already programmed to operate most RCA, GE and
PROSCAN branded TVs, VCRs, DVD players and SATELLITE receivers (DBS). Just press the
corresponding component key—
TV, VCR, DVD, DBS•SAT, CABLE, AUDIO
—and your six-
component universal remote is ready to go!
Indicator Light
—flashes when a valid key is pressed to indicate
the remote is working. Status of this light is important when
you are programming the remote.
Component Keys
(
TV
,
VCR
,
DVD
,
DBS•SAT
,
CABLE
,
AUDIO
)—
selects the component you want the remote to operate.
For example, after you’ve programmed the remote to operate
your TV, you must press the
TV
key first to put the remote in
TV Mode. While in TV Mode, the
CHAN
keys change the channel
on the TV, the
VOL
keys adjust the TV’s volume, etc.
Transport Keys
—
REVERSE
,
PLAY
,
FORWARD
,
STOP
,
PAUSE,
RECORD
—operate the same as your original VCR or DVD remote
control, although key labels may vary (
REWIND
,
FAST FORWARD
).
Backlight Key (select models only)
—turns backlighting on and off.
Backlighting remains on for approximately six seconds after the
last keypress to conserve battery life.
Your universal remote requires two new AA alkaline batteries (batteries may
or may not be included, depending on the model). To install the batteries:
3
Battery Information and Installation
6 Component
Universal Remote
Key Descriptions
1. Remove the battery compartment cover.
2. Insert the batteries, matching the batteries to
the (+) and (-) marks inside the battery case.
3. Replace the battery cover.
Note:
Reprogramming may be required after
batteries are replaced.
RCU600WMS_IB.qxd 6/5/03 16:55 Page 3
