DVD OR CD CODE
7
Program for SATELLITE—Direct Entry Method
In order for the six-component universal remote to control your DBS system, you must program
it with the code that matches your SATELLITE receiver. To program your remote to control your DBS
system, follow these steps:
1. Manually turn on the satellite receiver.
2. Locate the enclosed SATELLITE Code List. Find your
brand in the SATELLITE Codes.
Note:
If your brand isn’t listed, use one of the Code Search
methods to program this remote control. (See section on Code
Search on page 10).
3. Press and hold the
CODE SEARCH
key until the indicator
light illuminates. Then release the
CODE SEARCH
key.
4. Press and release the
DBS•SAT
key. The indicator light
blinks and then remains lit.
5. Use the number keys on the remote to enter the first code
listed for your brand. After you enter a valid three-digit code,
the indicator light turns off.
Note:
If you enter an invalid code, the LED flashes rapidly
for two seconds. Start over at step 3.
6. Aim the remote at the SATELLITE receiver. Press the
ON•OFF
key. If your SATELLITE receiver turns off, you have found
the correct code.
7. Enter the code in the box provided on this page
for future reference.
8. If your SATELLITE receiver does not turn off, repeat
steps 3-6 above, entering the next code for your brand.
If none of the codes work or your brand is not listed,
use one of the Code Search methods to program this
remote. (See Code Search section on page 10).
6. Aim the remote at the component. Press the
ON•OFF
key.
If your DVD/CD system turns off, you have found the
correct code.
7. Enter the code in the box provided on this page
for future reference.
8. If your DVD/CD system does not turn off, repeat steps
3-6 above, entering the next code for your brand.
If none of the codes work or your brand is not listed,
use one of the Code Search methods to program this
remote. (See Code Search section on page 10).
(BLINK)
DBS (SATELLITE) CODE
CODE
SEARCH
INDICATOR
LIGHT
(OFF)
ON•OFF
DBS•SAT
RCU600BL_IB.qxd 10/17/03 8:09 Page 7
