Congratulations on your purchase of the six-component universal remote
by RCA. This universal remote controls up to six electronic components
and makes juggling remote controls a thing of the past. You can program
this RCA universal remote to operate most models of most brands of
infrared, remote-controlled components manufactured after 1990. (See
enclosed Code List for a complete list of brands.) The six-component
universal remote is easy to use, easy to program and gives you control
at the touch of your fingertips.
Note:
The six-component universal remote is already programmed to operate
most RCA, GE and PROSCAN branded TVs, VCRs, DVD players and
SATELLITE receivers (DBS). Just press the corresponding component key—
TV, VCR, DVD, DBS•SAT, CABLE, AUDIO
—and your six-component universal
remote is ready to go!
Indicator Light—flashes when a valid key is
pressed to indicate the remote is working.
Status of this light is important when you are
programming the remote.
Component Keys (
TV
,
VCR
,
DVD
,
DBS•SAT
,
CABLE
,
AUDIO
)—selects the component you
want the remote to operate.
For example, after you’ve programmed the
remote to operate your TV, you must press
the
TV
key first to put the remote in TV Mode.
While in TV Mode, the
CHAN
keys change the
channel on the TV, the
VOL
keys adjust the
TV’s volume, etc.
Transport Keys—
REVERSE
,
PLAY
,
FORWARD
,
STOP
,
PAUSE, RECORD
—operate the same
as your original VCR or DVD remote control,
although key labels may vary (
REWIND
,
FAST FORWARD
).
Backlight Key (select models only)—turns
backlighting on and off. Backlighting remains
on for approximately six seconds after the last
keypress to conserve battery life.
Your universal remote requires two new AA alkaline batteries (batteries may or
may not be included, depending on the model). To install the batteries:
3
Battery Information and Installation
6 Component
Universal Remote
Key Descriptions
1. Remove the battery compartment cover.
2. Insert the batteries, matching the batteries
to the (+) and (-) marks inside the
battery case.
3. Replace the battery cover.
Note:
Reprogramming may be required
after batteries are replaced.
RCU600M_IB_resized.qxd 3/24/04 4:10 AM Page 3
