18
P R O B L E M
Red light not blinking when you press any key
The remote does not operate
your video devices
Not performing commands properly
Problems programming a TV/VCR
Combo Unit
VCR not recording
Problems changing channels
No response after pressing a key
SELECT
button not responding
Flashing Indicator Light
S O L U T I O N
A) Replace the batteries with 2 new AAA
alkaline batteries.
B) Check if batteries are properly installed.
A) Try all the codes listed for your brand.
B) Try the Code Search method on page 17.
Start Code Search over again to locate
the proper code for full compatibility.
Try the VCR code for your brand. Some
combo units, however, may require both
a TV and a VCR code for full operation.
As a safety feature on your remote, you must
press the
REC
button twice.
If your original remote required
ENTER
after
a channel, press
ENTER
after you select a
channel.
A) Make sure you have new batteries and you
are aiming your remote at your devices.
B) Check that batteries are properly
installed. See page 2.
Try using the
MENU or INFO
button to make
the selection while in the Program Guide.
Invalid Code for the device. Check the Code
list and reprogram the Remote Control.
Help Line
Trouble Shooting
If you need additional set-up help, please call the Help Line at:
1-800-420-7968
Note: Reprogramming may be required after batteries are removed.
RCU800manual 3/8/00 2:03 PM Page 19
