4
Button Description For Audio Operation
AUDIO OPERATION
(Rose Colored Graphics)
Press AUDIO button to enable the AUDIO mode
LEVEL+/LEVEL-
Sets the level of the speakers during test tone
mode.
DSP ON•OFF
Enables the receiverÕs Digital Signal
Processing mode.
DSP MODE
When the DSP mode is enabled, pressing this
button allows the user to cycle through
the various DSP modes.
CD, TAPE, TUNER, TV, VIDEO 1, VIDEO 2
The CD, TAPE, TUNER, TV, VIDEO 1, and
VIDEO 2 buttons are used to directly select
the device you want to control.
(Works in AUDIO mode)
AM•FM
The AM¥FM button allows you to select the
AM¥FM band on you audio receiver.
FUNCTION
Selects the different audio input devices. The
number buttons also select the function
labeled below the buttons when in
AUDIO
mode.
DELAY-, ON, DELAY+
Increases or decreases the delay between the
surround and main speakers when the
receiver is in the surround sound mode.
ON•OFF, SURR, MODE
ON¥OFF SURR toggles the surround modes
on and off. SURR MODE cycles through the
receiverÕs various surround sound mode
settings.
FRONT, CENTER, REAR, TEST
Adjust the levels of the front, center, and rear
speakers respectively used with Level + /
Level - . The test tone must be enabled first
by pressing the TEST button.
PRESET
Used to operate preset channels while in
Audio Mode.
RCU800manual 3/8/00 2:03 PM Page 5
