11
9. The Autosearch sends the next code
in the list every three seconds.
Note:
The Autosearch can take a
significant amount of time, since
there are many codes in the list.
10. To speed up the Autosearch, you can
manually override the process and
temporarily speed it up by pressing
the normal search keys (
CH+
,
CH-
,
ON•OFF
,
PLAY
,
LCD UP
, and
LCD
DOWN
keys) in both forward and
reverse directions.
11. If your device responds to the command,
and the RCU900RF sends the next code
before you have a chance to press the
LCD OK
key, you can backtrack
through the code library by pressing
CH-
or the
DOWN ARROW
. You can
change the direction to forward once
again by pressing the
ON/OFF
,
CH+
,
UP ARROW
, or
LCD PLAY
keys.
12. Once the device to be controlled responds
to the commands, press and release the
LCD OK
key to install the code.
13. The touchscreen returns to the Main
Setup Screen. The Code Search entry
is now complete.
Code Identification
Code Identification allows you to find out what codes are
programmed in the remote under a given mode (TV, VCR, DVD, etc.).
To find out the currently programmed code, follow these steps:
1. Press and hold the
SETUP
key on
the rubber keypad until the LED
indicator light remains on and the
touchscreen shows the Main Setup
Screen. This process takes
approximately 2-3 seconds.
2. Release the
SETUP
key.
3. Press and release the
LCD CODE
key. The LED indicator light blinks
off once to indicate acceptance of
the keypress.
4. The touchscreen now shows Device
Setup Screen. Press and release the
device key on the rubber keypad for
the device whose code you want to
identify (
TV
,
VCR
,
SAT/CBL
, etc.).
The LED indicator light blinks
once to indicate acceptance of
the keypress.
5. The touchscreen now shows the
Code Setup Screen. Press and release
the
SETUP
key. The LED indicator
light blinks off once to indicate
acceptance of the keypress.
6. The touchscreen now shows the
Code ID Setup Screen (initially blank
except for
LCD SETUP
,
INFO
and
CODE
keys). The touchscreen then
shows the code, using the LCD
digits. The digits in the three-digit
code are shown in sequence for
Summary of Contents for RCU900RF
Page 15: ...15 Device Device ...