The bottom view of the TV
(Front cabinet faces down)
TV ANT
FM ANT
TV signal output
1
3
2
Install and Connect TV
Setup your TV
1.Put your TV in a place that can support the
weight of the TV.
To avoid danger, please do not assemble
the TV near water or extreme heat(such
as a furnace, light source,or candle.)
Do not block the ventilation on the back
of the TV.
Connect signal source and power
2. Connect the antenna cable to the RF
connection on the back or side of the TV,
and/or the signal source HDMI cable to the
HDMI input(s) on the rear or side of TV. Plug
the TV into the wall power outlet (AC120 ~ 60Hz).
Turn on the TV
3.Connect the power supply, enter the standby
mode (red light), press the power button of the
TV or the power button on the remote control to
turn on the TV(No light).
Note:
Picture for reference purposes only.
TV Feet Installation Instructions
11
1.Open the carton and remove the TV,accessories,and the feet.
2.To avoid damage to the TV,place on a table,face down on a
soft surface. The feet are attached to the TV with provided
screws,or are attached by snapping into the cabinet till you
hear the click.
3.Ensure the feet are tightened/snapped-in securely. Do not
overtighten.
Please take note of the base direction:
Summary of Contents for RNSM2403
