Rear Panel
1
1
Power Cord
Jack for supplying power to the unit.
Connect to a wall outlet.
2
2
Analog 5.1 Speaker Out Jack
Connect each of the speaker wires to
the satellite speakers.
Speaker cords, 1 for each speaker, are
needed for connection.
When connecting the speakers, make
sure the polarities ("+" side of the
speaker wire to "+" on the receiver) of
speaker wires and terminals are
matched.
3
3
Connection to Antenna Cable
Connect a coaxial cable from your
cable wall outlet or antenna to the
ANT IN jack on the back of your
DVD/VCR unit.
4
4
AM Antenna Jack
5
5
S-Video Output Jack (DVD only)
6
6
COMPONENT (Progressive) Out Jack
(DVD only)
To obtain better screen quality,
connect the unit to a TV or monitor
with a COMPONENT(480i or 480p)
input.
Note:
VCR signal is only available
from Composite Video Out jack and
RF Out. You must always connect
these to the TV in order to set up and
use your unit.
7
7
Subwoofer Pre-Output Jack
Connect an active subwoofer to
improve bass performance especially
in a large room.
8
8
A/V Output Jack
9
9
A/V Input 2 Jack
;
;
A/V Input 1 Jack
A
A
Connection to TV
Required connection for VCR
operation. Connect on end of the RF
cable to the RF Out Jack on the back
of the unit and the other end to the
ANT IN jack on the back of your TV.
B
B
FM Antenna Jack
Identification of Controls
FRONT-R
FRONT-L
REAR-L
WOOFER
REAR-R
CENTER
SPEAKER
COMPONENT OUT
IN 1
IN 2
OUT
S-VIDEO OUT
WOOFER OUT
AUDIO
ANT.IN
AM
FM
RF.OUT
R
L
VIDEO
Pr
Pb
Y
IMPEDANCE USE 6
Ω
(WOOFER USE 6
Ω
)
4
1
2
3
4
5
6
7
8 9 0
A
B
RTD300 EN 7/25/03 2:36 PM Page 8
