Limited 90 Day Warranty
Thomson multimedia Inc. warrants that for 90 days from date of
purchase, it will replace this product if found to be defective in
materials or workmanship. Return it postage prepaid to the
Product Exchange Center address for prompt, no charge
replacement with a current equivalent. This replacement is
Thomson multimedia Inc.’s sole obligation under this warranty.
Thomson multimedia Inc. will not be responsible for any inci-
dental or consequential damages or for any loss arising in con-
nection with the use or inability to use this product. Some states
do not allow the exclusion or limitation of incidental or conse-
quential damages, so the above limitation or exclusion may not
apply to you. This warranty excludes defects or damage due to
misuse, abuse, or neglect. This warranty gives you specific legal
rights, and you may also have other rights, which vary from
state to state.
18
© 2001 Thomson multimedia Inc.
Product Exchange Center
11721 Alameda Ave.
Socorro, TX 79927
PRCU600RS Rev0401
Trademark(s) ® Registered
Marca(s) Registrada(s)
Made In Indonesia
www.rca.com
P RO B L E M
Red light not blinking when you
press any key
The remote does not operate
your video devices
Not performing commands
properly
Problems programming a
TV/VCR Combo Unit
VCR not recording
Problems changing channels
No response after pressing a key
SELECT
button not responding
Flashing Indicator Light
S O L U T I O N
A) Replace the batteries with 2
new AAA alkaline batteries.
B) Check if batteries are properly
installed.
A) Try all the codes listed for
your brand.
B) Try the Code Search method
on page 16.
Start Code Search over again to
locate the proper code for full
compatibility.
Try the VCR code for your
brand. Some combo units,
however, may require both
a TV and a VCR code for full
operation.
As a safety feature on your
remote, you must press the
REC
button twice.
If your original remote required
ENTER
after a channel, press
ENTER
after you select a
channel.
A) Make sure you have new
batteries and you are aiming
your remote at your devices.
B) Check that batteries are
properly installed. See page 2.
Try using the
MENU or INFO
button to make the selection
while in the Program Guide.
Invalid Code for the device.
Check the Code list and
reprogram the Remote
Control.
Trouble Shooting
Note: Reprogramming may be required after batteries are removed.
For Customer Service, contact the RCA Help Center at: www.rca.com
17
RCU600RS manual 4/11/01 12:15 PM Page 18
