13
Setting Up the VCR
F.
Cable box not used for all channels:
Press
2
. You are finished with
CABLE BOX SETUP
.
Skip
to Step 8.
Cable box used for all channels:
Press
1
to continue.
Press two numbers on the remote to enter the channel
that your VCR receives signals from your cable box.
(Press
0
before a single-digit number. Valid numbers are
01 – 13
.)
If you connected your cable box to the VCR using the
boxÕs
AUDIO/VIDEO OUT
jacks, press
INPUT
to select
VIDEO1
or
VIDEO2
.
Press
CLEAR
on the remote to correct an entry.
G.
Press
MENU•PROG
to proceed.
This message appears:
The VCR will now receive all
signals from the DSS receiver on
É .
H.
Press
MENU•PROG
to proceed.
I.
Manually Controlled Cable Box:
You are finished with
cable box setup. Press
MENU•PROG
to exit.
Proceed to
Step 8.
Remote Controlled Cable Box:
Enter your cable box
code from the chart on the next page and follow the on-
screen directions. The VCR changes the cable box from
channel 02 to channel 09 when you enter the correct code
for your cable box.
If none of the codes work, try repositioning the cable box
and entering the codes again. If the codes still do not
work, this VCR cannot control your cable box during
VCR Plus+ or timer recordings. Press
MENU•PROG
to
exit the
CABLE BOX SETUP
.
Proceed to Step 8.
Manual cable box or DSS® setup.
If you ever want to individually set up the cable box or
satellite receiver:
A.
Press
MENU•PROG
to display the
VCR MAIN MENU
on
the TV screen
.
B.
Press
4
to select
CHANNELS
menu.
C.
Select
Cable box
or
DSS® Setup
.
¥
Press
5
to select
Cable box Setup
.
¥
Press
6
to select
DSS® Setup
.
D.
Follow the directions on the screen
as
shown in step 7.
DSS¨ is a registered trademark of DIRECTV, Inc., a unit of Hughes
Electronics Corporation.
Startup
CABLE BOX SETUP
Do you use your cable
box to receive ALL
channels?
1 Yes
2 No
CABLE BOX SETUP
On what channel does
the VCR receive signals
from the cable box
(usually 3, 4, or video)
--
Press 01-13 or INPUT
Press MENU to exit
CABLE BOX SETUP
The VCR will now
receive all signals
from the cable box
on channel 03
CABLE BOX SETUP
Enter the code for your
cable box from the
list in your User's
Manual.
--
CABLE BOX SETUP
Please turn on the
cable box and tune
it to channel 2.
Press MENU to proceed
CABLE BOX SETUP
Did the cable box
tune to channel 9?
1 YES, setup is complete
2 NO, try again
VCR MAIN MENU
1 VCR Plus+
2 Timer Recordings
3 Time
4 Channels
CHANNELS
1 Auto Channel Search
2 Add/Remove Channels
3 Signal Type: CABLE
4 VCR Plus+ Channel List
5 Cable box Setup
6 DSS Setup
0 Exit
