1
2
3
Removing or inserting the Bobbin
switch off the machine while doing this.
Open the hook cover.
Setting Spool Pins
upper
thread
tangle
hole
upper thread
to use pull up the spool pin. push down for
storage. if the thread would slip down from the
spool, thread through the hole of spool pin as
shown.
cross the cotton in a figure of eight
for good tension.
raise the needle by turning the balance
wheel toward you. take out the bobbin case
by holding the latch.
When inserting the bobbin case, place
the horn into the recess of the hook
race. switch the machine back on.
Draw thread from spool. guide the thread around the bobbin winder thread guide. insert the
thread through one of the holes in the bobbin from the inside to the outside. put the bobbin on
the bobbin winder spindle, and push it to the right. With the free end of the thread held in your
hand, depress the foot control. stop the machine when it has made a few turns, and cut the
thread close to the hole in the bobbin. Depress the foot control again. When the bobbin is fully
wound, it will be stop automatically. return the bobbin winder to its original position by moving
the spindle to the left, and cut the thread.
9
Winding the Bobbin
E
N
g
LiS
h
