Threading Bobbin Case
place bobbin into bobbin case.
Make sure the thread unwinds
in the direction of the arrow.
Threading the Machine
Draw the thread under the
tension spring and into the
delivery eye. leave about
10 cm (4 inches) of free
thread.
10
pull the thread into the
bobbin case slot.
raise take-up lever to its highest position by turning balance wheel toward you.
raise presser foot.
place spool on spool pin as shown, with thread coming from the back of the spool.
1.
Draw thread into thread guide using both hands.
2.
Draw thread into the other thread guide.
3.
While holding thread near spool, draw thread down into the tension area and around, then
check spring holder.
4.
Firmly draw thread up and through take-up lever from right to left.
5.
Draw thread down and slip it into needle bar thread guide.
6.
thread needle eye from front to back. you may want to cut the end of thread with a pair of
sharp scissors for easier needle threading.
switch on the power after threading the machine and bobbin. you are now ready to sew.
Always thread your machine with the power off !
4
2
3
5
6
1
1
2
3
5
6
4
E
N
g
Li
S
h
