Reverse Stitch Control
Adjusting Stretch Stitch Balance
to select stretch stitches, set this
control at ss position. in stretch
stitch sewing, stitch length control
should be in the center position
between - and + (ss position) for
most materials.
Depending upon the type of fabric
used you may need to adjust this
control to match forward stitches of
stretch sewing with reverse motion
stitches.
to shorten stretch stitches, turn
the control slightly toward “-” to
lengthen, turn toward “+”
as long as you keep pressing the
reverse stitch control down,
the machine sews backwards.
to put on the Darning plate:
1. position the darning plate with the 3
pins on the bottom.
2. Fit the darning plate pins into the
needle plate holes. the feed dogs will
show through the darning plate holes.
stitch selector
s s
use left needle position for more control while
topstitching or edge stitching difficult fabrics.
NOTE:
Only use the zigzag presser foot when
sewing with the needle in left position.
13
stitch length
setting mark
ss
stitch length control
-
+
Darning Plate
Left Needle Position
E
N
g
LiS
h
