1
ENGLISH
SETTING (REAR PANEL)
POWER SELECTOR
Note:
Use a screwdriver to select.
OFF position: the loudspeaker is disabled (muted).
a)
100 V (/ 70 V) constant voltage line
Select the desired power (referred to a 100 V line) among 10 – 15 – 30 – 60 W.
When using a 70 V line (instead of 100 V), the power is halved: 5 – 7.5 – 15 – 30 W.
b)
Low impedance input
Select the 8 Ω position.
WARNING: Do NOT set the 8 Ω position when the loudspeaker is connected to a 100 / 70 V constant
voltage line.
‘VOICE / MUSIC’ REAR PANEL SWITCH
The ‘VOICE / MUSIC’ switch allows to optimise the frequency response according to
the main use.
Select ‘voice’ when announcements (with or without background music) and the speech
intelligibility is more important than music.
Select ‘music’ when the loudspeaker is mainly (/ only) used for music.
INSTALLATION
Loudspeakers are to be installed by qualified personnel, respecting all safety standards.
Loudspeakers are to be installed securely.
Make sure the supporting structure (i.e. plasterboards / wood panels) has the necessary mechanical
characteristics for the loudspeaker weight, without the risk of a fall that could damage things or
cause an injury.
a.
Mount the 2 coupling shorter parts to the ends of the wall-
mounted support (picture 1), but without tightening too much
(as it may be later necessary to adjust the loudspeaker
horizontal aiming angle).
b.
Fix (vertically) the support to the wall with 4 (M5) dowels.
Picture 2:
screw through a wall-mounted support hole.
Note:
the connecting cable (if inside a flush-mounted pipe) can pass through
the wall-mounted support central hole.
•
•
(picture 1)
(picture 2)
