41
ENGLISH
SYS CONFIG > GPI-VOX SUBMENU
Settings of the 12 logic inputs (GPI) of the main unit (and amplifiers) and the MAIN IN VOX
function.
‘VOx’
iS
a
fuNcTiON
ThaT
auTOMaTicallY
deTecTS
The
audiO
SigNal
preSeNce
(
abOVe
a
predefiNed
ThreShOld
)
ON
The
MaiN iN
iNpuT
.
Choose either
MAIN UNIT GPI
to access the main unit GPI list or
BOARD GPI
to access
the selected board GPI list.
N
OTe
:
iN
The
gpi
liST
,
lOgic
iNpuTS
ThaT
haVe
alreadY
beeN
aSSigNed
are
Marked
bY
a
dOT
iN
brackeTS
afTer
Their
NaMeS
.
Select a logic input to enter its respective submenu:
CONFIG:
SET PRIO
Priority setting (lower number: higher priority).
MONITORING
It enables (
On
) / disables (
Off
) GPI line monitoring.
STATUS
GPI default status. Choose either
Normal Open
or
Normal Close
(normally open/closed).
ENABLE
It enables (
On
) / disables (
Off
) the selected GPI.
ASSIGN:
selection of the function to be assigned to the logic input (see the following table).
FUNCTION
DESCRIPTION
NO FUNCTION
No function assigned to the logic input (GPI).
MUTE
It allows to mute a channel or an amplifier that belongs to either a
zone, a group or the entire system.
UNMUTE
It allows to unmute a channel or an amplifier that belongs to either
a zone, a group or the entire system.
EVENT RESET
Reset.
EVENT SILENT
It stops playing the message that is assigned to an evacuation /
alert event.
EVENT
REACTIVATE
It resumes the playback of the message that is assigned to an
evacuation / alert event and has been previously stopped.
EVENT GEN
It creates an event, chosen among evacuation, alert, all clear, fault
and test.
It allows to select the message to be assigned to the event (the
choice is among 8 messages per event type) and the destination
area (note: this is not possible in case of fault indication).
ROUTINE
MESSAGE
Playback of a routine message (chosen among the ones available
on the used SD card) due to the activation of a logic input (GPI).
LOAD PRESET
It loads a preset (among 64), to change the allocation of audio
signals on the 4-channel RCF bus.
NIGHT&DAY
VOL
Selection from a preset list (up to 32) to set the audio level at night.
AUX IN
ROUTING
It sends MAIN IN / AUX IN to a group or a zone.
PSU FAULT
The logic input is used to control the secondary power supply
(48 V dc).
SYS CONFIG >
GPI-VOX SUBMENU
Summary of Contents for MX 9502
Page 2: ......
