10
ENGLISH
LEDS ON THE BOTTOM PANEL COVER
d
uring
The
speaker
sTarT
-
up
(
afTer
swiTching
on
,
ca
. 15
seconds
)
all
The
4 led
s
are
flashing
.
From left to right:
1 AC (green)
When lit: AC power supply (mains: 230 / 115 V) is present and the speaker is operating.
2 DC (green)
When lit: 24 V DC power supply is present and the speaker is operating.
If batteries are not connected (or not available) or the voltage is lower than the minimum
threshold, this LED will be off.
i
f
boTh
AC
and
DC
led
s
(
only
)
are
flashing
,
The
speaker
is
in
sTand
-
by
mode
.
3 FAULT (yellow)
When lit: a fault has been detected.
4 PRIORITY (red)
When lit: the priority function (of the PRIORITY AUDIO INPUT
4
) is activated by the
respective contact
6
.
LEDS ON THE BOTTOM PANEL
COVER
NOTES ABOUT THE RDNET SOFTWARE
RDNET SOFTWARE INSTALLATION
The
RDNET
software is protected by international copyright laws and is to be used to
configure the
RCF RDNET
system devices only.
It is not allowed to modify or change or try to decompile this software.
In no event shall RCF S.p.A. be liable to end-users for any damage whatsoever, including
but not limited to financial damages for loss of business profits or business information
due to the software use or inability to use this product.
The foregoing provision is effective even if RCF S.p.A. has been advised of the possibility
of such damages.
Even if the SOFTWARE has any material, verifiable and reproducible program errors, RCF
S.p.A. shall have no obligation to modify such errors.
M
iniMuM
RequiReMent
:
a
PC
with
either
M
iCrosoft
‘w
indows
® V
ista
’
or
‘7’
(
or
later
)
oPerating
systeM
,
haVing
an
aVailable
Usb
Port
.
Before installing a new software release, it is necessary to remove the previous
version (if installed). Verify also that the new release is the right one for the PC
operating system: either 32-bit or 64-bit.
Run rcf_rdnetsetup_(versione).exe to start the setup wizard.
Click NEXT > to proceed.
