71
B) Extract the used MMC and
insert a brand new MMC. Press
[KONTANT]
After a few seconds a not fiscal receipt is printed with data referred to the
initialling of the new E.J. support.
Press the key [VOID REC./VOID] to exit the menu.
Press 1 + KEY to go back to Recordings mode.
Continue with the recording of the items.
13.1 FILLING UP THE LABEL
The label on the electronic journal support (E.J.) must be duly filled up
before utilising the MMC. Enter the following data:
•
Cash counter serial number
•
Cumulative number of the electronic journal
(E.J.)
13.2 PRUDENCE IN OPERATING THE MMC
•
Do not operate the MMC if the ONDA S feeder is insufficient
•
Do not remove MMC when transferring the data or while the
device is ON (except in the procedure of replacement of full MMC)
•
Do not take away the feeder to the machine during the
reading/writing of the data in the MMC
•
Do not force the insertion (and extraction) of the MMC in the
connector
•
Keep MMC clear of any source of heat and humidity and do not
place it in the open sun.
INSERT NEW MMC
Press a key
72
14. ERROR MESSAGES LIST
CODE
DESCRIPTION
E01
“VALUE NOT VALID [CL] ”
It Indicates that the last key pressed is not matching the
current procedure
E02
“WRONG FUNCTION Press [CL] "
It indicates an error in the current procedure. Press CL and
verify again the entering of the data.
E03
“WRONG DATE Press [CL] "
The format of the date entered is incorrect (refer to chapter
6.9)
E04
"WRONG TIME Press [CL] "
The format of the hour entered is incorrect (refer to chapter
6.9)
E05
"WORD TOTALE NOT ADMITED [CL] "
It is not possible to program a word including the word
TOTALE.
E06
"BARCODE WRONG [CL] "
It Indicates that the barcode entered is wrong. Press CL and
verify the code again.
E07
"FISCAL CODE WRONG [CL] "
It Indicates that the barcode entered is wrong. Press CL and
try again.
E10
"MMC FORMAT NOT CORRECT! [CL] "
It Indicates that the MMC entered is other than the type
supplied by RCH. Enter only MMC supplied by RCH.
E11
“MMC ALREADY USED! [CL] "
It Indicates that the (electronic journal) inserted is not brand
new. Insert another brand new MMC.
E12
"E.J. ABSENT OR WRONG [CL] "
It indicates that MMC is missing (electronic journal), or that
the E.J. cumulative number is wrong. Insert a new MMC or
the proper E.J..
E14
“MMC WRITE ERROR!”
It indicates that an error occurred during the writing of the
data onto the electronic journal (E.J.). Switch off and switch
on again the cash counter, fully cancelling the current receipt
(Receipt void). Should the problem appear several times,
contact the service centre.