Description
The PDM-4 and PDM-8 board distributes a DC source into 4 or 8 outputs. The output volt-
age and total current available is determined by the input supply. When installed into a
power supply, service time can be greatly reduced by the output indicator LED’s. If an out-
put fuse is blown the accompanying LED will be off. Simply identifying the device
connected to this output will allow for a problem to be quickly corrected. In addition to
short circuit protection the input terminals also have a surge protector that can absorb a
1500 Watt spike or surge to protect connected devices.
Features
• Converts a single input to 4 or 8 separately protected outputs
• Separate RED power indicator LED for each output.
• Reverse polarity protected.
Installation Instructions
(See Fig. 1 and 2)
1) Mount the distribution board in a suitable location as required.
2) Connect power to input terminals, (-) is negative and (+) is positive.
Observe proper polarity
3) Connect devices to be powered to output CH terminals. Observe proper polarity.
4) Apply power to input terminals and test all connected devices.
Note:
•
Unit is to be powered from RCI 10 Series power supply or a UL listed power supply
•
Maximum torque of 7in*lb for black input and output terminals
•
Check end product install instructions for conditions of use