43
SQUEEGEE RUBBER BLADES (FIG.8)
The blades are fi tted to trap the water used for washing; they must therefore always be kept in perfect wor-
king order and replaced in case of breakage or wear.
Replacing the blades
CAUTION!
WHEN THE EDGE IN CONTACT WITH THE FLOOR SUFFERS ABRASION, THE SQUE-
EGEE BLADES MUST BE REPLACED.
A PERFECTLY STRAIGHT EDGE IS ESSENTIAL FOR PERFECT DRYING.
To replace the blades proceed as follows:
·
Remove the squeegee from the machine by raising it to the high position and remove the suction pipe
1.
·
Remove the split-pin A on pin B from the squeegee by unscrewing it downward.
·
Unscrew the eight knobs 2 on the rear strip 3 and the screws 4 on the front strip 5.
·
Turn the rubber blade 7 so that the fresh edge is used. The rubber blade is of reversible type and
all four edges can be used. If all the blade’s edges are worn, replace it.
·
Reverse the above procedure to fi t the new blades.
Proceed to adjust the squeegee.
Summary of Contents for JUMBO 1002 RN
