CHARGING THE BATTERY PACK
1
2
3
A Once the battery ready to be charged, first plug the AC quick charger into the outlet of AC power
source, and then connect the battery input/output harness to the charger.
B. Continued to monitor the battery as it is being charged. As soon as the battery is fully charged,
disconnect the battery. from the charger plug (Over-charging or charging incorrectly using inadequate
chargers may cause the battery pack to become dangerouslyhot).
C. For best results, let the battery pack cool before charging. Heat may prevent the battery pack from
charging to full capacity and also decreases the performance of the battery.
.
Lithium Polymer (Li-Po) batteries are becoming popular for use in R/C models due to their compact size,
high energy density, andhigh-current output. However, these types of batteries require special care and
handling procedures for long life and safe operation.
Warning:
Lithium Polymer (Li-Po) batteries are intended only for advanced users that are educated on
the risks associated with Li-Po battery use. THUNDER TIGER/ACE RC does not recommend
that anyone under the age of 16 use or handle Li-Po battery packs without the supervision of a
knowledgeable and responsible adult.
Important:
Do not use NiCd/Ni-MH battery chargers for Li-PO batteries. If you do not use a special
charger for Li-PO battery,they will be damaged.
Please note! Consumers for use or installation of lipo battery in the remote control model belongs
and cause any Direct or indirect damages, our company will not bear any legal liability.
AFTER CHARGE TIME EXPIRES, DISCONNECT
BATTERY PLUG FROM CHARGER PLUG.
PLUG INTO AC OUTLET.
CONNECT BATTERY PLUG
TO DC OUTLET PLUG FROM CHARGER.
LiPo BATTERIES
9
MID
1
2
3
4
5
6
7
8
9
Racing Steps
Open the cap of the radio
Put 4 AA batteries into the battery tank
(Please note the Positive and Negative )
Note:
1. In order to get the better control effect, we recommend you to use AA1.5 V alkaline batteries (not included in the
product), the ratio of 1.2 V rechargeable battery effect is better.2. Battery if installation errors of the pole, or long time
no management will lead leakage.3. Do not use the old battery and new battery hybrid together. 4.If long time idle, do not
leave the battery in the remote control.
Racing Operation Steps
Cover the cap of the radio
Properly installed antenna tube
put the battery into the battery tank
cover the battery box
Adjust the throttle, steering vernier
adjustment knob button to median
(MID) direction .big/small rudder
Angle knob button to 120%
Be sure to first open the remote control power, and then open the model car
power supply, switch on the power, the motor delivering a diz ~ diz ~ ~ ~ sounds,
it means the motor for standby state. open radio button, the motor will begin to run.
Finish racing note
Turn off the ESC and disconnect
the power plug.
Turn off the radio
Put out the battery
B
-
10E
10
C H A R G IN G T H E B A T T E R Y P A C K
1
2
3
A Once the battery ready to be charged, first plug the AC quick charger into the outlet of AC power
source, and then connect the battery input/output harness to the charger.
B. Continued to monitor the battery as it is being charged. As soon as the battery is fully charged,
disconnect the battery. from the charger plug (Over-charging or charging incorrectly using inadequate
chargers may cause the battery pack to become dangerouslyhot).
C. For best results, let the battery pack cool before charging. Heat may prevent the battery pack from
charging to full capacity and also decreases the performance of the battery.
.
Lithium Polymer (Li-Po) batteries are becoming popular for use in R/C models due to their compact size,
high energy density, andhigh-current output. However, these types of batteries require special care and
handling procedures for long life and safe operation.
Wa rning:
Lithium Polymer (Li-Po) batteries are intended only for advanced users that are educated on
the risks associated with Li-Po battery use. www.rcmitico.es does not recommend
that anyone under the age of 16 use or handle Li-Po battery packs without the supervision of a
knowledgeable and responsible adult.
Importa nt:
Do not use NiCd/Ni-MH battery chargers for Li-PO batteries. If you do not use a special
charger for Li-PO battery,they will be damaged.
P lea s e n ote! C ons umers f or u s e o r i ns ta lla tion o f l ipo b a ttery i n t he r emote c ontrol m odel b elongs
a nd c a us e a ny D irec t o r i ndirec t d a ma ges , o ur c ompa ny w ill n ot b ea r a ny l ega l l ia bility.
A F T E R C H A R G E T IME E X P IR E S , D IS C O NNE C T
B AT T E R Y P L U G F R O M C H A R G E R P L U G .
P L U G I NT O A C O U T L E T.
C O NNE C T B AT T E R Y P L U G
T O D C O U T L E T P L U G F R O M C H A R G E R .
L iP o B A T T E R IE S
9
9
8
manual_kapton.indd 8
07/10/13 19:56
