P.O Box 578 Casino, NSW, 2470 Australia
Phone: International ++614 2902 9083
Australia (04) 2902 9083
Website:
http://rcs-rc.com
E mail:
Info@rcs-rc.com
OMEGA-3v6s
E
lectronic
S
peed
C
ontroller
FULL INSTRUCTION MANUAL.
TABLE OF CONTENTS
PROVIDED IN INSTRUCTIONS.
Page # 1 Introduction.
Page # 2 Installing the
#
OMEGA-3v6s
ESC.
Page # 3 Installing RX into the
#
OMEGA-3v6s
.
Page # 4 Setting up the system.
Binding the RX.
Page # 5 Calibrating the system.
Page # 6 Programming the system.
Page # 7 Operating the System.
Speed & Direction control.
Using Sound Trigger functions.
Page # 8 MU’ing Consists of Locos.
Trouble shooting.
PLEASE NOTE. PDF WIRING INSTRUCTIONS ARE HERE:
http://www.rcs-rc.com/pages/instructions
Thank you for purchasing this Microprocessor based
E
lectronic
S
peed
C
ontrol
(ESC)
R/C system.
THESE INSTRUCTIONS REFER SPECIFICALLY FOR USE WITH
THE
RCS
TX-20 & TX-21+ HANDPIECES.
THERE ARE SEPARATE INSTRUCTIONS FOR USE WITH ANY 2.4
GHz R/C WITH 4 OR MORE CHANNELS.
THOSE OTHER INSTRUCTIONS REFER SPECIFICALLY TO THE
SPEKTRUM DX5e 2.4 GHz R/C.
THEY ALSO APPLY TO THE DX4e, DX6i & PLANET T5.
N.B.
YOU CANNOT MIX BRANDS OF R/C.
THE
RCS
#
OMEGA-3v6s
SYSTEM IS IN ONE PART WITH
SERVO LEADS TO PLUG INTO ANY DSM2 COMPATIBLE RX.
OR
; USE ANY BRAND OF R/C WITH THE ADDITION OF FOUR
SERVO LEADS CONNECTED TO THE 6 WAY SCREW
TERMINAL ON THE ESC AND PLUGGED INTO THE
APPROPRIATE CONNECTIONS ON THE RX.
INSTRUCTIONS.
THESE INSTRUCTIONS REFER TO OPERATING PROGRAM
RCS-v1
.
ESC’s WITH OPERATING PROGRAM RCS-v1 CAN BE USED WITH ANY STICK TYPE DSM2 TRANSMITTER.
#
OMEGA-3v6s
HAS BEEN CALIBRATED AT THE FACTORY. ONCE RX IS “BOUND” TO TX THE SYSTEM IS READY TO USE AS IS.
THERE ARE MANY FEATURES WITHIN THE SYSTEM WHICH CAN BE PROGRAMMED. YOU WILL NEED TO DOWNLOAD THE FULL
INSTRUCTION MANUAL FROM THE RCS WEBSITE. THE PUSHBUTTON ON THE ESC PCB IS ONLY USED FOR PROGRAMMING.
DO NOT PRESS THE ESC BUTTON DURING OPERATION.
DO N OT CONNECT TO MAINS POWER (110 – 240V AC).
THE
#
OMEGA-3v6s
CAN BE USED WITH ANY FILTERED DC SUPPLY SUCH AS BATTERY POWER.
THEY HAVE CONSTANT BRIGHTNESS DIRECTIONAL LIGHTS & 2 SOUND TRIGGERS.
THE FOLLOWING MAXIMUM VOLTAGES MENTIONED ARE THE
NOMINAL
VOLTAGE & TAKE INTO ACCOUNT THAT FULLY
CHARGED BATTERIES CAN & DO EXCEED THE
NOMINAL
VOLTAGE.
USE 14v – 20v FOR THE
#
OMEGA-3v6s
. A high voltage version is available on request.
We tested this system three times during manufacture. It was working normally when it left our factory.
If damage in transit has occurred, please return to place of purchase for attention.
THE ESC IS GUARANTEED FOR ONE YEAR.
The solid state motor driver output IC is guaranteed for life.
You will supply a locomotive or trail car, the 14 – 20 volt traction batteries (depending on ESC), a fuse,
ON-OFF switch and wires where necessary, to connect the ESC to the battery and motor(s).
Where soldering is necessary, we recommend a low wattage soldering iron and resin core solder.
TO AVOID CONFUSION WITH OTHER OPERATORS, WE SUGGEST YOU MARK THE TX TO
SHOW WHICH LOCO IT OPERATES.
CAUTION
DO NOT ATTEMPT TO ALTER THE TUNING OF THE RADIO EQUIPMENT.
DO NOT USE RADIO CONTROL EQUIPMENT IN THUNDERSTORMS.
CHILDREN UNDER 12: ADULT SUPERVISION RECOMMENDED DURING USE.
