Key LCD display Functions and Notes
1 Clamp A Position test To drive the clamp motor, and the clamp is switched to A position
2 Clamp B Position test To drive the clamp motor, and the clamp is switched to B position
3 Clamp C Position test To drive the clamp motor, and the clamp is switched to C position
4 Scan clutch test Engage the scan clutch (RD-3108C only)
5 Feed electromagnet test Engage the Feed electromagnet
6 Space motor test Drive the space motor
7 Ink pump motor test Drive the ink motor, automatically stops when the ink is full
8 Scan motor test Drive the scan motor and scan clutch (RD-3108C)
9 Print motor test Drive the print motor and plating clutch
Clear Cutter motor test Complete the cutting process (Attention about the danger of cutter)
All clear Plating clutch test Engage plating clutch
Speed + Drum test Drive the drum : unload(eject), load(feed) position and stop position
Speed - Indicator light All lights off / on
Space + Unload motor test Drive the unload motor
Space - Main motor test Drive the main motor (From low speed to high speed)
0 Sensor group 1
1 Cutter jog switch
2 Feed tray switch
3 Right cutter position switch
4 Left cutter position switch
5 Paper detect switch
6 Original ready sensor (RD-3108C)
7 (A)Original detect sensor (RD-3108C)
(B)Scan cover open/close switch (RD-4019A)
8 N/A
Master-making Sensor group 2
1 Middle paper jam sensor
2 Clamper drive position sensor
3 Drum stop(home) position sensor
4 Clamp B mode sensor
5 Clamp A/C mode sensor
6 Disposal box full switch
7 Master eject sensor
8 Right paper jam sensor
Test print Sensor group 3
1 Ink detect sensor
2 Space shift sensor
3 Space home position sensor
4 Master detect sensor
5 Drum jog switch
6 Drum detect switch
7 Front cover switch
8 Master feed covers switch( not available with RD4019A and 4029A)
Check the sensor as below (Note :the sensor is blocked-1, the sensor is unblocked-0).
(RD-3108C/3208C/4019A/4029A)
Unit test
- 27-
