声明:本说明书著作权归杭州睿登科技有限公司所有,未经允许任何单位或个人不得用于商业用途。
16
5.1
组装准备
5.Assembly Procedure
5.1 Assembly Preparation
● RD6012 digital power supply*1, S12A case*1, 70V800W switch power supply*1
● Tools, accessory(DC power supply, 3 pin plug cable, multimeter, screw driver, test pencil...)
● Proper assembly environment
It is recommend to use a 70V800W switch power supply as shown below.
5.2 Assembly step
Note:
The case material is a bit soft and may be slightly deformed during transportation. If
there is a gap during the assembly, please straighten it before assemble it.
①Check the accessories: check if the accessories of S12A are same as accessories list or
accessory picture.
②Check RD6012: Adjust input power supply to 12v/1A to power on RD6012, and set 5V/1A
output on RD6012, turn on the output to see if the output is normal.
③Back board assembly: install the rocker switch and AC power socket on the lower board.