EZ-RA6
EZ-CC6
SELECTED MOUNTING ACCESSORIES
TYPICAL PERFORMANCE
Rack Adapter
for 6 Increments of 1/6 Rack Width
Component Chassis
for 6 Increments of 1/6 Rack Width
EZ-UCB2
Under-Counter Brackets
1/6 or 1/3 Rack Width
Use In Place of Filler Panel
Holds Adapters and Cables
Mounts in EZ-CC6 and EZ-RA6
Complete accessory listing available at: rdlez.com
Copyright © 2010 Radio Design Labs, Inc. RDL, Radio Design Labs and the RDL logo are registered trademarks of Radio Design Labs, Inc. Data reflects product at publication time, subject to change without notice. “Made in USA” applies to all EZ products except power supplies.
Input:
Mic level, -60 to -30 dBu nominal
Input Impedance:
>1 k
Ω
balanced
Input / Output Connectors:
XLR
LEVEL Adjustment:
Single turn audio taper (front panel)
Minimum Input Level:
-60 dBu (to cross compressor threshold) @ max gain; -30 dBu (to cross compressor threshold) @ min gain
Maximum Input Level:
0 dBu @ min gain
Output:
Mic level, -55 dBu to -30 dBu, adjustable; NORMAL: -45 dBu
Output Impedance:
150
Ω
nominal, balanced
Output Level Adjustment:
Single turn audio taper (rear panel)
Frequency Response:
50 Hz to 20 kHz (+/- 0.5 dB)
THD+N:
< 0.5% (50 Hz to 20 kHz, at compressor threshold)
Compression:
30 dB, automatic adjusting attack and release times
Noise:
<-63 dB (below normal output level at comp. threshold, -56 dBu input)
CMRR:
> 55 dB (50 Hz to 120 Hz)
Phantom:
24 V (IEC 1938: 1996-12), present when phantom detected at module output
Indicators (3):
Red LED: COMPRESSION, indicates compressor activity; Green LED: PHANTOM, indicates phantom voltage present; Blue LED: POWER
24 Vdc power supply current:
55 mA (idle), 60 mA (max.), 70 mA (max. with phantom)
Power supply input voltage:
100 to 240 VAC
Warranty:
3 Years; contact RDL technical support department for assistance
Case dimensions:
2.9” (7.4 cm)W x 3” (7.6 cm)D
Mounting size:
1/6 rack width
891-1645
EZ-DC1
EZ-SMB1
Desktop Chassis
1/6 Rack Width
Surface Mount Bezel
for 1/6 Rack Width Products
EZ-SD1
Storage Drawer
1/6 Rack Width
