FLAT-PAK
™
SERIES
Model
FP-TPS4A
Format-A Two-Pair Audio Sender
Installation/Operation
EN55103-1 E1-E5; EN55103-2 E1-E4; EN60065
Typical Performance reflects product at publication time exclusive of EMC
data, if any, supplied with product. Specifications are subject to change
without notice. This product is Professional Apparatus.
Radio Design Labs Technical Support Centers
U.S.A. (800) 933-1780, (928) 778-3554; Fax: (928) 778-3506
Europe [NH Amsterdam] (++31) 20-6238 983; Fax: (++31) 20-6225-287
891-2175A
RJ45 Standard Wiring
TYPICAL PERFORMANCE
Inputs (3):
20 k
Ω
unbalanced (2, left and right); 100 k
Ω
balanced (mono amplified)
Input Connection:
Phono Jack (Unbal.); Mini-jack (Bal.)
Input Level:
-10 dBV unbalanced; 1 W (8 Ohms) to 10 W (8 Ohms) balanced, 2 W nominal
Format-A Signal Pairs Used (2): B, C
Output:
RDL TP Format-A
Output Connection:
RJ45
Frequency Response:
10 Hz to 50 kHz (+/- 0.1 dB)
THD+N:
<
0.05%
Noise below +4 dBu:
< -85 dB
Crosstalk:
< -85 dB (10 Hz to 10 kHz); < -80 dB (10 kHz to 20 kHz)
Headroom above +4 dBu:
> 18 dB
Indicator:
Power
(Input and outputs active)
Power Connection:
Power Jack (locking)
Power Requirement:
24 Vdc @ 30 mA plus connected loads
Maximum Load Current:
500 mA
Dimensions:
4.15" (10.5 cm) L; 3.25" (8.6 cm) W; 1.68" (4.27 cm) H
(1) +
White
/
Green
(2) –
Green
(3) +
White
/
Orange
(4) –
Blue
(5) +
White
/
Blue
(6) –
Orange
(7) +
White
/
Brown
(8) –
Brown
Pair A: Audio +4 dBu
Pair B: Audio +4 dBu
Pair C: Audio +4 dBu
Pair D: Power +24 Vdc
Tab on bottom of connector
RJ45 conductor colors shown are for 568A standard. The 568B standard may be used if the connectors at both ends of the cable are wired identically.
