EC7000i and EC7500i User Guide
Status signals for EC7000i and EC7500i
Status signals for EC7000i and
EC7500i
The scanner’s status is shown through a single, multi-state LED (light-emitting diode), which is the light
on the top, front, right-hand side of the unit. Additionally, the scanner beeps to provide more information.
The tables below describe typical status signals and their meanings.
EC7000i light signals and beeps
The following tables are for EC7000i scanners with serial number 24x and higher. Your scanner’s serial
number is listed on the bottom of the unit. For more information on finding your serial number, see
Model
and serial number
.
Scanners with serial number 23x and below might also have these signal patterns if they are updated to
firmware 5.4.0 or higher. For more information on what firmware your scanner is running, contact your
distributor (reseller).
If your scanner has a serial number of 23x or lower and does not follow these signal patterns, your
scanner has an older set of signals. See
Appendix A
for a list of those patterns.
Startup
Signals
Meaning / What to do
Red-green-amber flashing cycle
followed by a solid amber light
and then a long solid red light.
The scanner is starting up and performing diagnostics. Wait for the
scanner to finish.
Green solid
The scanner is configured but idle. The scanner is ready.
Document scanning and processing
Signals
Meaning / What to do
Green flashing
The scanner is waiting for the user to insert a document into the
feeder.
Green-red flashing cycle
The scanner is processing the document. Wait for the scanner to
finish.
Red flashing and short beep
An error occurred during processing. Check the computer or terminal’s
display for instructions or refer to your scanning application’s
documentation. If you need more help, contact your distributor
(reseller).
©2014 RDM Corporation
Page 16
