EC9100i and EC9600i Series Scanner User Guide
Operating the scanner
©2016 RDM Corporation
Page 24
Imaging identification cards
The ID imager uses the same track as the document scanner, but you insert ID cards at the back of the
scanner. Insert the card into the scanner so that the front of the ID card faces away from the scanner.
The ID imager scans both the front and back of the identification card.
1.
Insert the identification card into the back of the scanner track until you feel the scanner pinch
the card.
The scanner pulls the card through the track.
2.
Remove the card from the front of the scanner track.
Understanding light signals
The scanner’s status is shown through a single, multistate LED (light-emitting diode), which is the light
on the top, front, right-hand side of the unit. The tables below describe typical status signals and their
meanings.
EC9100i series signals
Signals
Meaning
After starting the scanner:
Red and green flashing cycle
The scanner is being configured by the scanning application.
Green solid
The scanner is ready and idle.
When scanning:
Green flashing
The scanner is waiting for the user to insert a document into the
feeder.
When scanning:
Green and red flashing cycle
The scanner is processing the documents. Wait for the scanner to
finish.
When scanning:
Red flashing
An error occurred while the scanner was processing the document.
Check your PC application for instructions or refer to your local
procedures. If you need more help, contact your distributor (reseller).
