REACH CL4000
(
Powolive
™)
User Manual
Copyright © SZ Reach Tech Co., Ltd.
10
/
47
LED of the device will be constantly ON after the device starts up. The hard disk LED will
flash constantly and quickly until the startup completes.
Before shutting down the device, please make sure that the device has stopped
recording and that the parameters have been saved. Then turn off the power switch on the
rear panel of the device, thus protecting the hard disk and preventing data loss.
3.2 LCD Panel
After the device starts up, some information about the device’s status will be
displayed on the LCD panel, such as the operating status, equipment model, IP address,
subnet mask and gateway, etc.. The device model will be displayed as “CL4000xxxxxx”,
and the IP address, subnet mask and gateway will be displayed in turn as
“xxx.xxx.xxx.xxx”.
3.3 Buttons on the Front Panel
The users can use the buttons on the front panel to control the quick record, after the
device runs normally. The button’s LED indicates the current operating status of the
device.
Mute button: The LED is off by default. It will be ON after the button is pressed,
indicating that the sound is disabled during streaming. Press it again, the LED will be OFF
and the system will recover to the normal live streaming.
Start record button: The LED is off by default. When it is in stop record or pause mode,
the LED will be ON and the system will start to record after this button is pressed.
Meanwhile, the Stop Record LED or Pause LED will be OFF. It will start to record all the
audio, video and computer screen signals connected with the device.
Stop record button: The LED is ON by default. When it is in recording mode, the
system will stop recording and the Stop Record LED will be ON after this button is pressed.
Meanwhile, the Start Record LED will be OFF.
Pause button: The LED is OFF by default. When it is in recording mode, the system
will pause recording and the Pause LED will be ON after this button is pressed. Meanwhile,
the Start Record LED or Pause LED will be OFF. Press the “Quick Record” button to
recover to the recording mode.