CONNECTING THE YRC1000 AND FORGE/OS
THROUGH ETHERNET
Forge/OS must be able to communicate with the Yaskawa controller. This section will help
you connect the Forge hub device and YRC1000micro using an Ethernet cable.
Route Ethernet cabling from the Forge hub to the Yaskawa controller.
1
Connect one end of the Ethernet cable to the
LAN
port on the back of the YRC1000micro.
2
Plug the other end of the Ethernet cable into a LAN port on the Forge hub device.
3
Reconnect the YRC1000micro, Forge hub, and other devices to their power sources.
4
VERSION 1.0.0
© 2021 COPYRIGHT READY Robotics ALL RIGHTS RESERVED
14