Thank you for buying this product, our company is sure that you will be more than satisfied with
the product’s performance. The product is supplied with a
“Warnings”
leaflet and an
“Instruc-
tion booklet”
. These should both be read carefully as they provide important information about
safety, installation, operation and maintenance. This product complies with the recognized
technical standards and safety regulations.
1) GENERAL OUTLINE
The control panel is supplied by the manufacturer with standard settings. Any alteration must be
set by means of the incorporated display programmer or by means of UNIPRO. The Control unit
completely supports the EELINK protocol. Its main characteristics are:
- Control of two low-voltage motors up to 40W power
- Electronic torque setting with obstacle detection
- Limit-switch control inputs
- Separate inputs for safety devices
- Incorporated rolling-code radio receiver with transmitter cloning
- Soft start and close
The IGEA-BT (24V) is suitable for residential use and has been designed for swing gates with
particularly large gate posts. The drive arm, built with a special anti-shearing shape, allows the
leaves to be moved when the controller is considerably out of place with respect to the fulcrum of
the leaves. The non-reversible electro-mechanical motor maintains the stop during closing and
opening. The release knob with personalized key, fitted outside each operator, makes manual
operation extremely easy.
2) SAFETY
If correctly installed and used, this automation device satisfies the required safety level stan
-
dards. However, it is advisable to observe some practical rules in order to avoid accidental
problems. Before using the automation device, carefully read the operation instructions and
keep them for future reference.
• Keep children, persons and things outside the automation working area, particularly during op-
eration. An incorrect installation or improper use of the product can cause damage to persons,
animals or things.
• Keep radio control or other control devices out of children’s reach, in order to
avoid any unintentional automation activation.
• Do not intentionally oppose the leaf movement.
• BFT and Real Carriage Door & Sliding Hardware declines all responsibility for any consequenc-
es resulting from failure to observe Good Technical Practice when constructing closing structures
(door, gates etc.), as well as from any deformation which might occur during use.
• The installation must comply with the provisions set out by the following directives: 89/336/CEE,
73/23/EEC, 98/37/EEC and subsequent amendments.
• Do not attempt to open the gate by hand, if the actuator has not been released by means of
the appropriate release knob.
• Do not modify the automation components.
• In case of malfunction, disconnect the power supply, activate the emergency release to gain
access to the actuator and request the assistance of a qualified technician (installer).
• Before proceeding to any external cleaning operation, disconnect the main powers supply and
at least one of the battery pole, if fitted.
• Check that grounding is carried out correctly: connect all metal parts for closure (doors, gates
etc.) and all system components provided with an earth terminal.
