• Fit all the safety devices (photocells, electric edges etc.) which are needed to protect the area
from any danger caused by squashing, conveying and shearing, according to and in compliance
with the applicable directives and technical standards.
• Keep the photocell optical components and luminous signal indication devices clean. Check
that the photocells are not obscured by branches or shrubs.
• For any direct assistance to the automation system, request the assistance of a qualified
technician (installer).
• Have qualified personnel check the automation system once a year.
• Entrance is reserved for vehicles, provide a separate entrance for pedestrians.
3) SCRAPPING
Warning: This operation should only be carried out by qualified personnel. Materials must be dis
-
posed of in conformity with the current regulations. In case of scrapping, the automation devices
do not entail any particular risks or danger. In case of materials to be recycled, these should be
sorted out by type (electrical components, copper, aluminum, plastic etc.).
4) DISMANTLING
Warning:
This operation should only be carried out by qualified personnel. When the control unit
is disassembled to be reassembled on another site, proceed as follows:
• Disconnect the power supply and the entire electrical installation.
• In the case where some of the components cannot be removed or are damaged, they must be
replaced.
5) FUNCTIONS
FOR THE INSTALLER: Fill in the table with the parameters set, in order to facilitate future modifi
-
cations and maintenance operations. The preset values are indicated between square brackets
[ ].
WARNINGS
Correct controller operation is only ensured when the data contained in the present manual are
observed. The company is not to be held responsible for any damage resulting from failure to
observe the installation standards and the instructions contained in the present manual.
The descriptions and illustrations contained in the present manual are not binding. The Company
reserves the right to make any alterations deemed appropriate for the technical, manufactur-
ing and commercial improvement of the product, while leaving the essential product features
unchanged, at any time and without undertaking to update the present publication.
ATTENTION!
The IGEA-BT model controller is not equipped with mechanical torque adjustment.
It is compulsory to use a control panel of the same manufacturer, in compliance with the basic
safety requirements of directives 73/23/CEE, 89/336/CEE, 89/37/CEE equipped with appropriate
electric adjustment of the torque.
Correct controller operation is only ensured when the data contained in the present manual are
observed. The company is not to be held responsible for any damage resulting from failure to
observe the installation standards and the instructions contained in the present manual.
The descriptions and illustrations contained in the present manual are not binding. The Company
reserves the right to make any alterations deemed appropriate for the technical, manufactur-
ing and commercial improvement of the product, while leaving the essential product features
unchanged, at any time and without undertaking to update the present publication.
