Scanning Channels
Use scanning to monitor channels and codes for transmissions or to find someone in
your group who has accidentally changed channels.
To start scanning, briefly press and release
“ MON”
. The scan indicator displays .
When the radio detects channel activity, it stops scanning and you can hear the
transmission. To respond to the transmission, press within 5 seconds.
Note:
If your radio's Interference Eliminator Code is set to
while scanning, the radio
checks for activity on each channel regardless of the code used on the channel.
If your radio's Interference Eliminator Code is set to
, the radio checks for
activity only on channels using codes
and
Advanced Scan
If the radio stops scanning on a channel you do not want to listen to, briefly press and
release
or
to resume scanning for the next active channel.
Removing Channels from the Scan List
To remove a channel so the radio does not stop on it while scanning, press and hold or
for at least 3 seconds, then release. This temporarily removes the channel from the
scan list.
To restore the channel, turn the radio off and then back on.
Note:
You cannot remove the channel your radio was set to when you started the scan
(called your home channel).
18
Special Features
Special Features
+
l
+
l
ignores channels using code .
Realtree 10-01-04.qxd 10/1/04 12:14 PM Page 20