Cross Installation Straps
behind tree. Attach to the top
rung of the bottom ladder section.
Pull to tighten the straps against
the tree.
(See Installation Strap
Instructions).
8
S
After the ladder stand has been
secured to the tree with the installation
straps, and the stabilizer bar has been
securely attached to the tree, continue
to have two people hold the ladder,
climb cautiously up to the platform.
Once you reach the top,
IMMEDIATELY ATTACH YOUR
SAFETY HARNESS TO THE TREE.
Keep the tether strap above our head.
8
6
90º
7
90º
DO NOT climb ladder without Stabilizer Bar and Installation Straps installed. Serious
injury or death may occur if Stabilizer Bar and Installation Straps are not installed.
W A R N I N G
7
Installation Instructions Page 2
Model: RTLS-310
15’ Ladderstand
Customer Service Department 1-866-972-6168
www.primalvantage.com/realtree
S
9
Before sitting down
IMMEDIATELY
wrap the strap
of the Ratchet Strap around the back of the tree
once and thread through the ratchet.
(See Details
Ratchet Instructions Below).
9
T
Distributed by Acheson Harriman Swan, LLC, 2407 W. Euclid Ave., Littleton, CO 80120
©2021 (rev. 1/21)
R
L
DETAILED BUCKLE STRAP INSTRUCTIONS
1
2
3
4
Pull strap to desired length.
Press down on latch and
insert strap underneath
teeth as shown.
Pull slack to tighten.
Hold buckle as shown.
T
Tie one end of Tiedown Rope
to the inner part of Stabilizer Bar
near the flanged end. Wrap the
rope around the back of the tree
once. Then tie the other end of
the rope to the Stabilizer Bar .
6
L
L
R
