Attach Foot Platform to the inside of Yokes using
1-M8x60mm bolts
on each side.
5
H
60
E
5
E
7
7A
H
Attach one end of the Platform Support to the
OUTSIDE
of Foot Platform using
1-M8x40mm bolt
for each side. Attach the other
end of Platform Support to the
INSIDE
of
Handle Rail using
1-M8x40mm bolt
on
each side.
F
6
E
G
G
40
40
F
E
G
6
40
40
strap passes
through this
metal loop
Q
7
Carefully tilt ladder stand assembly forward so that the
underside of the seat is facing you and the top is facing
forward. With Horizontal Jaw Assembly Strap passed through the top
loop of Vertical Jaw Assembly Strap , connect the two right/left ends of
the Horizontal Jaw Assembly Strap to the Jaws using
2-M8x45mm
bolts .
Check to make sure that Vertical Jaw Assembly Strap is
passing through the metal loop on the bottom of the Foot Platform
Assembly (as shown above).
O
Q
Q
M
O
M
8
Attach the Ratchet Straps on either side
of the top rear Tree Connection Brace
on the rear of the Handle Rails
(as shown above).
(See Ratchet Strap
Instructions for correct weaving).
Attach Installation Straps on either side
of the top rear Tree Connection Brace
on the rear of the Handle Rails in front of the
Ratchet Straps .
(See Installation Strap
Instructions for correct weaving).
8
J
S
F
T
T
T
T
J
S
S
60
45
7A
NOTE: When fastening the Horizontal Jaw Strap
to the Jaws , the bolts must be inserted as follows.
Curved Jaw -
Insert
1-M8x45mm bolt
through
the Horizontal Jaw Assembly Strap fastener and then
through the top of the Curved Jaw .
Straight Jaw -
Insert
1-M8x45mm bolt
through
the Horizontal Jaw Assembly Strap fastener and then
through the bottom of the Straight Jaw .
Q
M
M
M
45
45
45
45
Assembly Instructions Page 2
Model: RTLS-310
15’ Ladderstand
Distributed by Acheson Harriman Swan, LLC, 2407 W. Euclid Ave., Littleton, CO 80120
Customer Service Department 1-866-972-6168
www.primalvantage.com/realtree
Q
O
From
bottom
Straight
Jaw
Curved Jaw
From
top
©2021 (rev. 1/21)
