Slide the inner part of the Stabilizer Bar
into the outer part. Attach Stabilizer Bar
to the second rung of the Middle
Ladder Section with
1-M8x45mm bolts .
Insert the Adjustment Knob in the
Stabilizer bar at the proper adjustment
point to the tree.
1
3
4
5
2
Position bottom of stand 4-5 feet from base of tree.
1
One person will stand at the base of ladder with
his/her foot on the bottom rung while holding
installation straps. This will prevent tree stand from
sliding. Two people will stand at opposite ends of
tree stand, facing platform and slowly walk tree
stand upward using rungs of ladder.
2
Move base of ladder toward or
away from the tree slightly in
order to make Platform as
Parallel to the ground as
possible.
Apply your full weight to the first
step so it settles into the ground.
5
As tree stand is being raised, the
person holding Installation Straps will
pull toward themselves to take up slack.
It will steady and ease the weight of
stand on the other two people. Continue
walking stand upward, until Tree
Connetion Brace is resting against the
tree.
Drawings are for illustration purposes only and may not depict actual product.
3
4
S
O
45
45
90º
Stabilizer Bar and Installation Straps MUST be secured prior to climbing the Ladder Stand.
Failure to comply may result in serious injury or death.
W A R N I N G
Installation Instructions Page 1
Model: RTLS-314
15’ Extra Wide Deluxe Single Man Ladderstand
Customer Service Department 1-866-972-6168
www.primalvantage.com/realtree
O
B
S
B
Distributed by Acheson Harriman Swan, LLC, 2407 W. Euclid Ave., Littleton, CO 80120
©2021 (rev. 1/21)
