18
User’s manual
EN
•
Charge the vehicle only with the included/authorized charger.
• Do not continue driving when the battery reaches minimum, as this will affect battery’s
life.
•
Warning: during continuous large current discharge (after about 15 seconds, of e.g.
a long-time climbing a very steep slope) the vehicle will enter into power off mode.
Charging
1. Plug the charger into mains socket (100 – 240 V; 50/60 Hz). The indicator on the
charger lights up green.
2. Plug the other end of the charger into the vehicle. The indicator on the charger will
turn red.
3. When the indicator turns from red to green, the charging is complete. Disconnect
charger from the device and power mains outlet. Do not overcharge the device, as
it may affect battery life.
Specifications of battery
•
Rechargeable lithium-ion battery
•
Voltage: 36 V
•
Capacity: 4,0 Ah
•
Working temperature: -15ºC~+50ºC
•
Storage temperature: -10ºC~+40ºC
•
Charging temperature: 0ºC~+40ºC
•
Relative storage humidity: 5~95%
•
Approximate charging time: up to 180 minutes
•
Charger:
•
Input: AC 100-240 V, 50/60 Hz
•
Output: DC 42 V; 1,5 A
CALIBRATION OF THE DEVICE
The cruiser is ready to use after unpacking.
During use, especially when driving on uneven ground, the device may get decalibrated.
Decalibration of the device causes the cruiser unsuitable for further use, which is
signalized by flashing red indicator on the device. In such case, it is necessary to perform
a calibration. Calibration will tune the gyroscope and its sensors, which might have
gotten distorted as a result of shocks or impact during driving.
To calibrate the device:
1.
Make sure the device is powered off.
2.
Place the cruiser on flat and even ground. It’s important to make sure that both
wheels are on the same level.
3. Once you have made sure that both wheels are positioned correctly and the device is
stably placed on even ground, press and hold the power button for about 5 seconds,
until the red indicator starts to flash.
