LEARN MORE
For more information on this device visit: www.rebelelectro.com.
Read owner’s manual carefully before using your device.
Visit www.rebelelectro.com website for more products and accessories.
English
Correct Disposal of This Product
(Waste Electrical & Electronic Equipment
(Applicable in the European Union and other European countries with separate collection systems) This marking
shown on the product or its literature, indicates that it should not be disposed with other household wastes at the
end of its working life. To prevent possible harm to the environment or human health from uncontrolled waste
disposal, please separate this from other types of wastes and recycle it responsibly to promote the sustainable
reuse of material resources. Household users should contact either the retailer where they purchased this product,
or their local government office, for details of where and how they can take this item for environmentally safe
recycling. Business users should contact their supplier and check the terms and conditions of the purchase
contract. This product should not be mixed with other commercial wastes for disposal.
Made in China for LECHPOL ELECTRONICS Sp. z o.o. Sp.k., ul. Garwolińska 1, 08-400 Miętne.
8
9
EN
EN
Hot air soldering
1. Place the hot air soldering iron on the stand.
2. A suitable nozzle must be installed.
Note:
Do not push the nozzle in or pull the edges of the nozzle with pliers. Also, do not
over tighten the screw.
3. Turn on the hot air soldering iron with the button next to the hot air soldering
iron connection socket. Cold air flow turns on.
4. Use buttons to set temperature and air flow level.
5. Use a solder tape for soldering.
6. Apply the proper quantity of solder paste and install the SMD on the PWB.
7. After finishing work, turn off the hot gun with the button next to the hot air
soldering iron connection socket. Cold air flow turns on. After about 1 min. turn
off control unit.
Hot air desoldering
1. Place the pick-up tool under the chip, choosing the appropriate width.
2. Put the nozzle on the pins of the IC (do not touch directly), so that the hot air can
melt the solder tin on the IC pin, and then use the tweezers to remove the IC.
3. After finishing work, turn off the hot gun with the button next to the hot air
soldering iron connection socket. Cold air flow turns on. After about 1 min. turn
off control unit.
SPECIFICATION
Central unit
Power supply
AC 220-240V, 50 Hz
Fuse
3.15 A
Soldering iron
Power consumption
60 W
Temperature range
160 – 480°C
Heating element
Ceramic
Hot air gun
Air flow
24 L/min (max)
Power consumption
320 W
Temperature range
160 – 480°C
In set
4 nozzles, FP pick-up tool, user
manual
Summary of Contents for LUT0062
Page 10: ......
Page 11: ...www rebelelectro com...
