REBOTEC /
BA-Nr.: 02.07.081/2021-10-A01
- 6 -
EN
•
The Infection Protection Act must be complied
with.
Please make sure that the product does not
pose a risk of infection when returned.
Enclose the supplied information sheet on
safety with the product.
Costs may incur for returns that are not marked
non-objectionable.
7. Reuse, lifetime
•
The product is suitable for reuse. How often the
product can be reused depends on the frequency
and nature of use.
•
Before reuse, the product must be reprocessed hy-
gienically and the technical and functional safety
and reliability of the product must be checked and
restored if necessary. See 13.
For more detailed information, please see the
reprocessing instructions (02.12.156) and the
maintenance instructions (02.11.150).
The documents can be downloaded from the fol-
lowing link.
▪
•
When used as intended, the product has a lifetime
of 5 years. The effective lifetime may vary depend-
ing on the frequency and intensity of use and the
general condition.
8. Scope of delivery
•
1 toilet wheelchair or shower/toilet wheelchair
•
1 User manual (02.07.081)
•
1 Allen key
The reprocessing and maintenance instructions can
be ordered or viewed and downloaded at
9. Setting up for use
•
The product has been carefully inspected in the
factory for freedom from defects and complete-
ness. Please check the product for any possible
damage which may have occurred during transport
and for completeness of the scope of delivery upon
receipt. Assembly or adjustment shall be carried
out by the specialist dealer.
9.1. Folding down the footrests
•
Turn (1) the footrests forwards until they engage
automatically. Fold (2) the footrests down. Adjust
the height of the footrests if necessary.
9.2. Adjusting the footrest height
•
The footrest height can be adjusted in 7 positions.
Loosen and remove the screws on the side of the
footrest using an Allen key (SW 5). Select the ap-
propriate height level (1-7) and screw the footrest
back in place. Make sure that the screws are firmly
tightened!
9.3. Assembling the backrest
•
The armrests must
be swivelled backwards for
mounting the backrest.
•
Put the backrest on
the tubes and then swivel
the armrests forward until
the bolts engage. See 11.3.
1
2
Max
Min
