AIARM 2004-01-01 12:00:00
PLAY -> STOP 60P
DATA 2004-01-01 12:00:00
PLAY -> STOP 60P
Blade-900_21
Playback – event search
Event search simplifies the search for a specific alarm event.
To activate this function, make sure that the digital recorder is in standby mode. First stop recording if active
(only the green should be on). Proceed as follows:
1. Briefly press Playback (3).
The red menu LED lights up.
2. Press Alarm (7).
The monitor displays the following:
ALARM means that the digital recorder is searching the hard
disk for recordings triggered by an external alarm contact.
1A is the first event found.
Up to 255 events can be stored. 255A is always the oldest
event, 1A always the latest.
To jump to the next event, press Alarm (7) again.
To play back this event:
1. Press Stop (c).
2. Press Play (9).
The event is played back.
IMPORTANT:
If no alarm event has been recorded, the digital recorder displays NO ALARM on the monitor.
Playback – time search
Date and hour search simplifies the search for a specific time.
To activate this function, make sure that the digital recorder is in standby mode. First stop recording if active
(only the green ON/OFF LED should be on). Proceed as follows:
1. Briefly press Playback (3).
The red menu LED lights up.
2. Briefly press Search (6).
The monitor displays the following:
DATE means that the digital recorder is searching the hard
disk day by day.
To jump to the next day, press FWD (d); to jump to the previous day, press REW (a).
To start playback:
1. Press Stop (c).
2. Press Play/Enter (9).
Playback starts.
